how to make dolphin emulator run faster on mac

Immediately run Dolphin before opening anything, including your browser. Also, if you have been running your computer for some time, leave it off or on sleep mode for a while to allow it to cool down and then start fresh. Make sure no other programs are running on your computer and that no other windows are open. This first tip might seem rather basic, but it can definitely help.Continue to use the general Dolphin settings outlined above and follow the tips below, but this patch should dramatically speed up gameplay, especially in notoriously slow Hyrule Field areas.Īuthor - Nat Zen Other Tips for Faster Gameplay in Twilight Princess MAKE SURE that the 'Hyrule Field Speed Hack' is checked (the default might leave it unchecked, as it did on mine). Leave the drop-down next to it on 'playable', but now go to the 'Patches' tab. Now, near the bottom, you will see a 'Hyrule Field Speed Hack' patch enabled. If you use Dolphin 5.0 (or a later version, I would imagine), right-click on the game title as you would in the steps above (in your main Dolphin window game list), go to properties, and then look at the 'Game Config' tab. It is a small thing to put up with, however, when the game might be too slow to even play without applying these changes. You will also notice that the changes we have made so far make the character's eyes, rugs, wall hangings, and a few other graphics incomplete (with empty horizontal lines cutting through the graphics).

If you look at the screenshots, you will see that the map is faded, but in most locations, you can make it out well enough to get by. If you are using the latest version of Dolphin, this last hack will make the map turn into a useless pixely square, but in 3.0, it’s at least weakly visible. Once again, we are sacrificing graphics for speed, but it’s necessary. At approximately the fifth to the bottom, you’ll see “EFBToTextureEnable = False.” Delete “False” and type “True” in its place, so that you have “EFBToTextureEnable = True.”

Right click on the game in the Dolphin startup window, and then click on “Properties.” At the bottom, you’ll see a button for “Edit Config.” Click on it, and then scroll down to the very bottom.

Click again on “Options,” and then go to “Graphics Settings.” Select Direct3D9 next to Backend, and for your Fullscreen Resolution, leave it on the lowest setting (640 x 480).Then, farther down check “JIT Recompiler.” Under the Audio tab, check “DSP HLE Emulation.” Leave the rest on default settings. Make sure both “Enable Duel Core” and “Enable Idle Skipping” are checked. Click on “Options” at the top of the startup window, and then click on “Configure.” The first tap shows General settings.

How to make dolphin emulator run faster on mac